CAUSES OF SHUTDOWN AND SLOW DOWN OF MAIN ENGINE

 Main engine safeties


Causes of shut down

  • Engine over speed.
  • Main and thrust bearing low low oil pressure.
  • Thrust bearing high temperature.
 Causes of slow down
  • High temperature of
a)     Lube oil inlet
b)     Piston cooling oil
c)     Main and thrust bearing
d)     Cooling water inlet
e)     Scavenge air
f)      Exhaust gas
  • Low pressure of
a)     Piston cooling oil
b)     Main and thrust bearing oil
  • High oil mist

2 Comments


>> Your Comments are always appreciated...
>> Discussion is an exchange of knowledge It Make the Mariner Perfect.... Please Discuss below...

  1. Overspeed
    Lube Oil Press. After Filter Low
    Oil Mist Concentration High
    Jacket Water Temperature High High
    Emergency Stop button
    Shutdown From GCC
    Generator Bearing temp. ND-End High
    Generator Bearing temp. D-End High
    Lube Oil Temp. Before Engine High High
    Lube Oil Press. After Filter Low Low
    Splash-Oil Temperature deviation High High
    HT Water Temp. Engine Outlet High High
    HT Water Pressur Low Low
    High Pressure Pipe Leakage A-Side
    High Pressure Pipe Leakage B-Side
    Outlet Viscosity From HFO Module High High
    Load / Load Trim Deviation High

    ReplyDelete
  2. We have slow down for Jacket water low pressure

    ReplyDelete
Previous Post Next Post