Pump Shaft Alignment Method And Procedure

>>> Straight edge and filler gauge method
  • Check gap at 12 &6 o’clock position.
  • Check straight edge at top.
  • Use shims to adjust the motor height & gap at 12 & 6 o’clock position.
  • Then check straight edge and gap at 3 & 9 o’clock position.
  • Use the motor jack to adjust it.




     >>Face and periphery method
  • Good for large diameter hub with short distance shaft end.




     >>>Reverse periphery method
  • Better than laser sighting method.




Post a Comment


>> Your Comments are always appreciated...
>> Discussion is an exchange of knowledge It Make the Mariner Perfect.... Please Discuss below...

Previous Post Next Post